Output Quality Analysis Procedures; Rap Hole Alignment Inspection Procedure; Rap Hole Skew Check - GBC AdvancedPunch Technical & Service Manual

Section 3

Output Quality Analysis Procedures

3.1 RAP Hole Alignment Inspection Procedure

3.2 RAP Hole Skew Check

Advanced Punch Service Manual
This section contains information related to the quality of the output such
as hole quality or alignment.
The holes in the paper should be in alignment from an end to end perspective as
shown in Figure 3.1. If not, go to
explained in Section 4.11
Figure 3.1 Hole Alignment on Finished Sheet.
This RAP explains the procedure to follow when the holes in the paper are not in
alignment along the margin of the paper. One end is further from the edge than
the other end as shown in
1. Inspect the Back Gauge Solenoid. It is free of Chad build up.
N. Clean the chad following procedure
Y. Go to next step.
2. Check the service records of this machine. The Back Gauge Assembly is within
the normal maintenance interval.
N. Replace the Back gauge Assembly as explained in procedure
© Copyright 2009 GBC. All rights reserved.
Section 4 and follow the adjustment procedure
Figure 3.2
1.4.11
4.8
3-1