Navigating To A Waypoint Or Point Of Interest; Restarting Cross Track Error (Xte); Following A Route; Following From Here - Raymarine LIGHTHOUSE 3 Advanced Operation Instructions

8.3 Navigation

Navigating to a waypoint or point of interest

You can perform a "Goto" to a Waypoint or specific location.
1. Select and hold on the waypoint or point of interest and select Goto from the context menu.
Goto at any time by selecting and holding anywhere in the Chart app and
You can stop the Goto Goto
choosing Stop Stop, or selecting another Goto Stop
2. The Chart app will begin navigation, if required physically engage your autopilot.
3. An alarm will sound when you reach the waypoint.
You can also perform a Goto from the Go menu: Menu > Go > Waypoint or Menu > Go > Lat/long.
For more information on waypoints and waypoint management refer to:
Routes and Tracks

Restarting cross track error (XTE)

A cross track error (XTE) occurs when your actual route diverges from your original planned route.
Restarting XTE plots a new course directly from your current position to your destination, rather than
continuing to follow the original planned route.
1. Select Restart XTE from the Navigation menu: Menu > Navigation > Restart XTE.

Following a Route

You can start active navigation / follow a route from its starting waypoint.
With the Route displayed in the Chart app:
1. Select and hold on any Route leg (line drawn between the Route's waypoints) that you want
to follow.
2. Select Follow Route.

Following from here

You can start active navigation / follow a route from any of its waypoints.
With the Route displayed in the Chart app:
138
Goto. Goto
Chapter 7 Waypoints,