Transducer Calibration (Itc-5); Network; Data Selection - Raymarine LIGHTHOUSE 3 Advanced Operation Instructions

Note:
In some circumstances, it is beneficial to disable Realvision AHRS if local sources of magnetic
interference are distorting the sonar image. Realvision AHRS can be disabled from Settings.
Menu > Settings > Sounder > AHRS stabilization
Note:
The Calibration process will require repeating after a Sonar reset or MFD Factory reset.

Transducer calibration (iTC-5)

You can calibrate transducers connected to your Lighthouse MFD via an iTC-5 Instrument Transducer
Converter.
Note:
Transducer calibration requirements:
• An iTC-5 Instrument Transducer Converter.
• An MFD designated as the Data master.
• LightHouse software version 3.11 or later.
Note:
You can only calibrate transducers that are directly connected to the iTC-5 instrument you select
for calibration. In systems with more than 1 iTC-5, it is important to remember which transducer(s)
are connected to each iTC-5 instrument.

Network

To calibrate transducers, find the relevant iTC-5 unit from the list of devices connected to your
MFD's network.
1. Open Network
Homescreen > > > Settings Homescreen Homescreen Settings > > > Network Settings
2. Find and select the iTC-5 unit.
3. Select Calibrate.

Data selection

You can choose which data type you want to calibrate:
• Depth
• Wind
• Speed
Set up
Network Network
47