Raymarine LIGHTHOUSE 3 Advanced Operation Instructions page 252

Settings
Ping rate limit
Power mode
Ping rate
Dual channel ping
mode
Tune frequency
AHRS stabilization
Reverse
Port/Starboard
Interference
rejection
2nd echo rejection
Reset sounder
Reset trip
Note:
The fish detection tab is only available when viewing a high CHIRP sonar channel.
252
Description
Allows you to restrict the transducer's maximum
ping rate to suit current conditions.
Adjusts the transducer's signal strength. In Auto
the sonar module will automatically determine
the optimal power based on current depth,
speed and bottom signal. In Manual you can
adjust the power to the desired level.
Hyper ping should be used at speeds of up to
40 knots in shallower waters (6 metres or less).
When the depth reaches 6 metres or above the
ping rate will automatically reduce to normal until
depth conditions are met.
On sonar modules that offer simultaneous dual
channel operation, such as the CP570, The ping
mode can be changed.
Auto the Fishfinder app will select the best mode
chosen based on range settings.
Independent pings maximizes ping rate but may
introduce interference.
Simultaneous pings reduced ping rate and
reduces chance of interference.
Enables manual tuning of non-CHIRP frequency
channels.
The AHRS built in to the RealVision™ 3D
transducer is used to stabilize the sonar image
onscreen based on your vessel's detected
movements.
When a RV100 transducer is hull/step mounted
the transducer can be installed with the cable
orientated towards either the bow or the stern of
the vessel. On installations where the transducer
cable is orientated towards the stern of the
vessel then the Reverse Port/Starboard control
must be enabled.
Removes interference caused by other
transducers on your vessel or from vessels
equipped with transducers close by.
The control helps to remove false target returns
or false bottom that can be caused by signal
reflection.
Resets the sonar module to factory default
settings.
In installations that include a speed transducer
connected via the sonar module a trip log is
automatically recorded. Selecting this option
resets the sonar module's trip log.
Options
• 1 to 100
• 1 to 100
• Normal
• Hyper
• Auto
• Independent pings
• Simultaneous pings
• -50% to +50%
• On
• Off
• Enabled
• Disabled
• Auto
• Low
• Medium
• High
• Off
• Off
• Low
• High
• Yes
• No
• Yes
• No