Settings; Place Waypoint; Goto Waypoint - Raymarine LIGHTHOUSE 3 Advanced Operation Instructions

1. Place waypoint — Selecting Place waypoint places a waypoint at the latitude and longitude
specified in the notification. The special DSC waypoint symbol is used for waypoints created
from DSC notifications. DSC waypoints use the MMSI of the originating vessel as the waypoint
name. If subsequent DSC distress calls are received from the same vessel MMSI then after
selecting Place waypoint there will be 2 options to choose from:
• Replace waypoint — Selecting Replace waypoint will replace the existing waypoint with a
new waypoint using the updated notification details.
• Place new waypoint — Selecting Place new waypoint will create a new waypoint and add a
suffix (A.B.C etc.) to each new waypoint's name.
2. Goto waypoint — Selecting Goto waypoint sets a goto to the latitude and longitude specified in
the notification.
3. Clear message — Selecting Clear message clears the alert from the screen.
Note:
If position data is not included in the DSC notification then Place waypoint and Goto waypoint
options will not be available.

5.12 Settings

The Settings menu is accessible from the bottom of the Homescreen and contains important
information and settings for your MFD.
The Settings menu is divided into different tabs, the settings available are:
Tab Settings
• View hardware and software information about your MFD.
Getting started
• View cartography details for inserted chart cards.
• Update MFD software
• View the LoU disclaimer (Getting started tab).
• Change the user interface language.
• View the Regulatory approvals.
• Set boat icon and name.
Boat details
• Configure Sailing [Sailing vessel's only].
• Configure Minimum safe depth, height and width.
• Configure engines.
• Configure batteries.
• Configure fuel tanks.
Units • Configure preferred units of measurement.
• Configure Bearing mode.
• Configure variation.
• Configure GNSS (GPS) system datum.
• Set time differentials.
Homescreen 83