Adjusting Balance And Fade Controls - Raymarine LIGHTHOUSE 3 Advanced Operation Instructions

Menu item
Crossover (Low pass filter):
Crossover (High pass filter):
Multi-zone volume control:
Reset:
Diagnostics mode:
Page settings tab
Settings
Data Overlays
Edit split ratio

Adjusting balance and fade controls

From the Audio settings menu: Menu > Audio settings
1. Select the Balance setting field or the Fade setting field.
The Adjustment slider control is displayed.
366
Description
Allows you to select the crossover
frequency. The Low Pass Filter
(LPF) will block all audio frequencies
above the threshold you specify.
Selecting APF (All Pass Filter) will
allow all frequencies.
Allows you to select the crossover
frequency. The High Pass Filter
(HPF) will block all audio frequencies
below the threshold you specify.
Selecting APF (All Pass Filter) will
allow all frequencies.
Allows you to select independent
audio zones that are controlled by
multi-zone volume control.
Note:
Only available on Fusion audio
devices with multi-zone control.
Performs a factory reset and power
cycle of the SR200.
Note:
Only available on Sirius SR200
devices.
Displays the SR200's diagnostic
information.
Note:
Only available on Sirius SR200
devices.
Description
Enables configuration of Data overlays
Enables you to customize the position of the partitions in
splitscreen app pages.
Options
• 60 Hz
• 80 Hz
• 120 Hz
• APF
• 60 Hz
• 80 Hz
• 120 Hz
• APF
• Audio zones 1–12
• Reset
• Display diagnostics