Augmented Reality (Ar) Troubleshooting; Ar Options Not Available In Video App; Ar Flags Do Not Appear Directly Above On-Screen Target - Raymarine LIGHTHOUSE 3 Advanced Operation Instructions

23.8 Augmented Reality (AR) Troubleshooting

AR options not available in Video app

Possible causes
Wrong camera selected.
Compatible camera not detected.
AR200 not detected.
Incorrect LightHouse™ 3 software
version.
AR options turned off.

AR flags do not appear directly above on-screen target

Possible causes
AIS update rate
Camera Field of View (FOV) set
incorrectly.
AR200 interference
Deviation too high
Troubleshooting
Possible solutions
Ensure that the correct AR-compatible camera has been
selected in the Video app menu.
1. Ensure your camera is AR compatible.
2. Ensure your camera is correctly installed and networked
to your MFD.
1. Ensure your AR200 is correctly installed and on the same
network as the MFD from which you are using the AR
features.
Ensure that your MFD is running LightHouse™ 3 version 3.7
or above.
The Compass bar, AIS, Waypoint and Chart object flags can
be enabled and disabled from the ClearCruise settings page
(Video app > Menu > Settings > ClearCruise). Ensure relevant
options are enabled.
Note:
For AIS flags to be displayed, compatible AIS hardware
must be operational and connected to the same network
as your MFD.
Possible solutions
Depending on the classification of the target's AIS hardware,
transmitted position updates may be sent up to 3 minutes
apart and therefore the flag may appear up to 3 minutes
behind the actual onscreen target.
Ensure that the FOV setting reflects your camera's horizontal
FOV. Check your camera's documentation for FOV
specifications.
If your AR200 is installed in a location which includes a
source of magnetic interference large enough to affect AR
flag placement, you may need to re-install the AR200 in a
different location.
1. Reset the AR200 calibration by selecting Reset from
the AR200 calibration page: Homescreen > Settings >
Network > Data sources > Heading > Raymarine AR200
Attitude > Calibrate.
2. If the problem persists, you may need to move your
AR200 to a location with less magnetic interference.
415