System Status; Fault Code History - Raymarine LIGHTHOUSE 3 Advanced Operation Instructions

7. Fuel tanks levels and total fuel — When a tank reaches 20% of its capacity the level indicator
will turn red. Upto 5 fuel tanks are supported.
8. Current vessel speed (Speed Through Water).
9. Tab position — Indicates vessel tab position as a percentage with 0% being fully trimmed up
(stored) and 100% fully trimmed down.
10. Engine trim — Indicates the engine trim position. Numeric values will be displayed from between
25.0 and 10.0. When the trim number goes above 10.0 the numeric value will be replaced
by the boat on trailer icon.
Engine notifications
Engine notifications such as alarms and warnings will be displayed on the MFD screen.

System status

The System status is displayed in the center of the page.
When the system is started a scan is performed after which System OK is displayed.
No Communication is displayed if the engines are turned off or engine data cannot be detected.
If the system is restarted after a brief time the system scan is not performed.

Fault code history

The fault codes tab displays live and historical detected engine faults.
By default the Fault codes history tab displays fault codes for all engines. You can use the Filter
option to display fault codes for a specific engine.
Active and historical engine fault codes can also be viewed from the MFD's Alarm manager:
Homescreen > Alarms and selecting either Active or History tab.
Mercury VesselView app
319