Installing The Multi-Detector Drip Tray - Waters ACQUITY UPLC Operator's, Overview And Maintenance Manual

Installing the multi-detector drip tray

If your ACQUITY UPLC system has more than one detector, you must install
the multi-detector drip tray.
ACQUITY UPLC PDA/eλPDA detector in a split ACQUITY UPLC H-Class
system
Column heater
Sample manager -
flow through needle
Quaternary
solvent manager
Required materials
Multi-detector drip tray kit
To install the drip tray
1. Turn the ACQUITY PDA/eλPDA detector, laying it on its left-hand side.
2. Snap the extended plastic feet onto the bottom of the detector, and then
snap the anti-skid pads onto the extended plastic feet.
3. Secure the drip tray to the bottom of the detector, using the screws and
plastic rivets provided in the multi-detector drip tray kit.
a. Remove the two screws, move the drip tray into place, and then
reinstall the screws to secure the tray.
b. Install three plastic rivets to further secure the tray.
ACQUITY UPLC
PDA/eλPDA
Multi-detector
drip tray
ACQUITY UPLC
ELS detector
Plumbing the detector 25