Installing The Detector; Before You Begin; Unpacking And Inspecting; Unpacking The Detector - Waters 2489 Overview And Maintenance Manual

2

Installing the Detector

The detector requires connections to electrical power and to sample and waste
lines to operate in any standard laboratory environment. This chapter describes
how to install the detector, and connect it to the electrical supplies and to other
equipment in an HPLC system.

2.1 Before you begin

Requirement:
general, to set up and operate laboratory instruments and computer-controlled
devices and also how to handle solvents.
Before installing the detector, ensure that
• the required components are present.
• none of the shipping containers or unpacked items are damaged.

2.2 Unpacking and inspecting

Warning:
UV/Vis detector.
The detector is packed and shipped in one carton, which contains the following items:
• 2489 UV/Vis detector startup kit
• Power cord

2.2.1 Unpacking the detector

To unpack the detector:
1. Unpack the contents of the shipping carton. As you unpack the carton, check
the contents to make sure you have received all items.
2. Check the contents of the startup kit.
3. Save the shipping carton for future transport or shipment.
To install the 2489 UV/Vis detector, you should know how, in
To avoid injury, Waters recommends that two people lift the 2489
June 11, 2015, 715004752 Rev. A
Page 27