GE Vivid 3N Pro Series Service Manual page 388

GE M S
EDICAL YSTEMS
D FK091075, R
IRECTION
8-2-10-3 Control Console Bottom Cover (Upper Section) Removal Procedure (cont'd)
7) Loosen the two screws fastening the AC/VGA connectors box. These screws can be accessed from
the opened space at the rear of the gas spring using a long screw driver, as shown below:
8) Remove the four screws fastening the metal cover under the front part of the control console, and
remove this cover.
Metal
Cover
Screws
9) Remove the six screws fastening the bottom cover, three on either side.
10) Remove the bottom cover towards the rear of the machine.
8-18
04
EVISION
Figure 8-19 Removing Screws from the AC/VGA Connectors Box
Figure 8-20 Removing the Metal Cover and Bottom Cover Screws
Section 8-2 - Cover Replacement Procedures
V 3N P /E S
IVID RO XPERT ERVICE
Bottom
Cover
Screws
(one side)
M
ANUAL