GE Vivid 3N Pro Series Service Manual page 505

GE M S
EDICAL YSTEMS
D FK091075, R
IRECTION
8-8-4-4 Color Video Printer Installation - Procedure1
NOTE: The Installation Procedure is for units that are equipped with a previously-installed B/W printer and/or
VCR. The color printer option includes a shelf with fastening belt, on which the printer is placed.
NOTE: If a B/W Printer and VCR are not installed, then the Color Video Printer can be placed on the top surface
of the Vivid 3N ultrasound unit (below the keyboard) and secured with the belt.
1.) Raise the control console to its maximum height.
2.) If a B/W Printer and/or a VCR are installed, disconnect all the cables and remove the units.
3.) Remove the Metal Bottom Cover, beneath the front part of the control console, as described in
2-10 "Control Console Bottom Cover (Upper Section) Replacement Procedure" on page
4.) Remove the Compartment Tray as described in
8-105
5.) Remove the Compartment Base as described in
Section) Removal Procedure" on page 8-17
6.) Route the Color Printer cables, found in the compartment, and let them drop down through the
opening left after the Metal Bottom Cover was removed (see
7.) Re-install the Metal Bottom Cover, as described in
Section) Installation Procedure" on page
Note: Make sure that all the cables are fitted through the slot in the far end of the Metal Bottom
Cover, as shown in
Figure 8-117 Color Printer Cables through Metal Bottom Cover Slot
8) Remove the right and left screws located at the front of the lower section top cover, as shown in
Figure 8-118 "Top Cover Screws" on page
04
EVISION
Figure 8-117
Chapter 8 Replacement Procedures
8-6-7-3 "Gas Spring Removal Procedure" on page
8-2-10-3 "Control Console Bottom Cover (Upper
8-2-10-4 "Control Console Bottom Cover (Upper
8-19.
below.
8-136.
V 3N P /E S
IVID RO XPERT ERVICE
step 3, above).
M
ANUAL
8-
8-17.
8-135