Extron electronics NetPA Ultra Series User Manual page 8

Dante Controller ........................................ 75
Overview ........................................................... 75
Downloading and Installing Dante Controller ...... 76
Configuring a NetPA U 2002 SB Amplifier
in Dante Controller ............................................ 76
Device Name ................................................. 76
Receiver and Transmitter Names ................... 77
Dante Controller Naming Conventions ........... 77
Renaming the NetPA U 2002 SB Amplifier
in Dante Controller ........................................ 77
Renaming a Receiver or Transmitter............... 79
Finding a Dante Device IP Address ................ 80
Dante Controller Operation ................................ 81
Dante Transmitters and Receivers .................. 81
NetPA Ultra Series Transmitters and
Receivers...................................................... 81
Dante Routing Operation ............................... 81
Routing Devices ................................................ 81
Disconnecting Inputs from Outputs ................ 83
Dante Troubleshooting ....................................... 83
Simplifying the Network for Troubleshooting... 83
Troubleshooting the Network Interface ........... 83
Restarting Dante Controller ............................ 84
Remote Communication and Control ......... 85
Connection Options ........................................... 85
RS-232 Port .................................................. 86
AT Port .......................................................... 86
USB Config Port ............................................ 87
Verbose Modes ............................................. 87
Host-to-Device Communications ....................... 87
NetPA U 2002 SB-initiated Messages ............ 87
Using the Command and Response Tables ....... 88
Symbol Definitions ......................................... 88
Error Responses ............................................ 88
Hardware Reset Modes ..................................... 89
Command and Response Table ......................... 90
Object ID (OID) Number Tables ........................ 103
Input Path OIDs ........................................... 103
Output Path OIDs ........................................ 103
Mix-point OIDs............................................. 104
Troubleshooting ............................................... 104
Amplifier Fails to Exit Standby Mode
Promptly ..................................................... 104
Amplifier Enters Standby Mode Too Early ..... 105
Limiter/Protect LED Warning Indicators........ 105
Over Temp Indicator LED ............................. 105
Status Commands ....................................... 106
Extron Warranty ...................................... 108
NetPA U 2002 SB User Guide • Contents viii