Rack Mounting; Rack Ear Mounting; Bridge Plate Rack Mounting - Extron electronics NetPA Ultra Series User Manual

Rack Mounting

The NetPA U 2002 SB amplifier can be mounted onto a rack using one of the following
methods.
NOTE: The following figures show the NetPA U 2002 SB being installed; however, all

Rack Ear Mounting

The NetPA U 2002 SB amplifier ships with a set of rack ears, so that the half rack-width
amplifiers can be installed in a full rack-width space.
Mount the amplifier with the rack ears by doing the following:
1.
2.
3.
4.

Bridge Plate Rack Mounting

The NetPA U 2002 SB amplifier ships with a bridge plate connector to allow two amplifiers
to be connected together and form a full rack-width unit.
Mount two NetPA U 2002 SB amplifiers by doing the following:
1.
2.
3.
4.
XPA Ultra and NetPA Ultra Series amplifiers are installed in the same way.
Remove the rubber feet from the bottom of the amplifier if previously installed.
Attach the included rack ears (one long and one short) to the sides of the amplifier with
the four provided #6 machine screws (see figure 1,
1
Figure 1. Installing the
Insert the amplifier into the rack and align the holes in the rack ear with the holes on the
rack.
Secure the amplifier to the rack using the four provided 10-32 x 3/4" screws (
If the rubber feet are installed on the bottom of the amplifier, remove them.
Position two amplifiers upside down and next to each other.
Use the bridge plate connector and the four provided #4 machine screws to connect
the two amplifiers together (see
Attach the two short rack ears to the amplifiers with the four provided #6 machine
screws ( ).
2
1
).
2
NetPA U 2002 SB
figure 2 on page 6, ).
1
NetPA U 2002 SB User Guide • Installation
)
2
.
5