Extron electronics NetPA Ultra Series User Manual page 99

Command ASCII
Network Commands
Set DHCP On
E
View DHCP status
E
Set Dante IP/subnet/
E
gateway
View IP/subnet/
E
gateway
View MAC address
E
View Dante device
E
name
KEY:
Baud Rate: 38400
X# IP address
X$
Subnet mask
X% Gateway IP
X^
MAC address
X& Dante device name
X1%
DHCP status
Unit Response
}
D1EXPD ExpdD1
} X1%]
DEXPD
X# X$ X% }
I * * EXPD ExpdI
} X#
IEXPD *
} X^]
HEXPD
} X&]
NEXPD
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xx-xx-xx-xx-xx-xx
Dante device name Device names follow Domain Name System (DNS) hostname rules. Legal characters are
A-Z, a-z, 0-9, and hyphen (-). Names must begin with a letter and cannot end with a hyphen (-)
1 = enabled (default), 0 = disabled
NetPA U 2002 SB User Guide • SIS Command and Response
]
X# X$ X%]
* *
X$ X%]
*
Unit Response: Verbose 2/3
E13 is returned if DHCP is already enabled.
DHCP must be off in order for this
command to be accepted as valid (DHCP
is enabled by default). Dante device reboot
is also required for the command to take
effect.
X1%]
ExpdD
(verbose 2 and 3 response)
Using this command automatically turns
DHCP off. Dante device must be rebooted
for new IP configuration to take effect (see
the Reboot Dante device command in the
previous page)
X# X$ X%]
ExpdI * *
(verbose 2 and 3 response)
X^]
ExpdH
X&]
ExpdN
92