Downloading And Installing Dante Controller; Configuring A Netpa U 2002 Sb Amplifier In Dante Controller; Device Name - Extron electronics NetPA Ultra Series User Manual

Downloading and Installing Dante Controller

Dante Controller from Audinate is required to route transmitters and receivers and can be
used to configure Dante settings and monitor performance. Install Dante Controller on a PC
running Microsoft
to download the software, see the Dante Controller product page at www.extron.com.
To download Dante Controller:
1.
2.
3.
4.
5.
The installed Dante Controller program files are saved in:
C:\Program Files (x86)\Audinate\Dante Controller\DanteController.exe.

Configuring a NetPA U 2002 SB Amplifier in Dante Controller

Use a standard Ethernet cable to connect the NetPA U 2002 SB to a Dante network via the
rear panel AT port (see

Device Name

Multiple devices on the same Dante network can present difficulty in identifying individual
devices. To avoid confusion and difficulty, ensure the following steps are taken:
•
•
•
•
ATTENTION: It is essential that a Dante device be named before audio subscriptions
ATTENTION : Il est essentiel qu'un appareil Dante soit nommé avant l'établissement
In Dante Controller, a device can be renamed to identify the device on the audio network.
The default device name of the NetPA Ultra Series consists of the model name, followed by
the last six characters of the Dante interface MAC address (for example, NetPA-U-xxxxxx).
In addition to renaming the device, individual Transmitter (Tx) and Receiver (Rx) channels
can be renamed.
The Dante device name must be set before making any connections to other devices on the
Dante network. Renaming a device after making connections removes existing connections
to and from that device. Refer to
Controller
Windows 7 or newer. For full details about computer requirements and
® ®
From www.extron.com, hover over the Download tab at the top of the page.
From the Featured Software list, select Dante Controller.
From the Dante Controller product page, click the blue Download button.
Select Run to run the Dante Controller installer. Select Save to save the install file to run
at a later time.
If you choose to run the file, follow all prompts. If you saved the file, click the saved file
to begin installation when ready.
Rear Panel Features
Connect devices to the Dante network one at a time.
Rename each device before making audio connections in Dante Controller.
Rename each device with a unique and meaningful identifier.
Rename each device before the next device is connected to the Dante network.
with other devices are established. Existing subscriptions are removed when a device
is renamed.
des abonnements audio avec d'autres appareils. Les abonnements existants sont
supprimés lorsqu'un appareil est renommé.
on page 77 for renaming procedure.
on page 17) and power the device.
Renaming the NetPA U 2002 SB Amplifier in Dante
NetPA U 2002 SB User Guide • Dante Controller 76