Extron electronics NetPA Ultra Series User Manual page 85

NOTE: If there are multiple NetPA Ultra Series devices connected to the network
that have not been renamed, obtain the Dante interface media access code
(MAC) address of the desired device from the white label on the rear panel of the
device in order to identify it in Dante Controller.
The Device View dialog populates with the selected NetPA Ultra Series information.
Figure 83. Populated Device View Dialog Box
Click the Device Config tab (see figure 84,
6.
7. In the Rename Device panel, enter the new name of the device in the text field. No
spaces are allowed in the name. Names should be significant identifiers. For example,
enter NetPAUAmplifier-MainRack (
8. Click Apply ( ). A confirmation prompt opens.
3
1
2
Figure 84. Device Config Dialog, Rename Device
9. Click Yes (see figure 85,
Configuration dialog box. The new name is written to the Dante interface of the
NetPA Ultra Series amplifier. Repeat as necessary for all devices.
4
Figure 85. Rename Device Confirmation Dialog Box
) to open the Device Config page.
1
).
2
3
) to confirm the new name, then close the Device
4
NetPA U 2002 SB User Guide • Dante Controller 78