Remote Communication And Control; Connection Options - Extron electronics NetPA Ultra Series User Manual

Remote
Communication and
Control
This section describes how to control the NetPA U 2002 SB power amplifier with SIS
commands and covers the following topics:
•
•
•
•
•
•
•
•

Connection Options

The NetPA U 2002 SB can be remotely connected via a host computer or other device
(such as a control system) attached to the rear panel RS-232 port, AT port, or the USB
Config port.
The NetPA U 2002 SB amplifier can be set up and controlled using SIS commands or
DSP Configurator software (see
configuration and control port connections. For information on DSP Configurator, see
Accessing the DSP Configurator Help File
SIS Commands can be sent to Dante audio interface devices through a DMP Plus device.
To learn how to do this, visit www.extron.com and read any of the user guides from the
DMP Plus series of matrix processors, such as the DMP 128 Plus.
SIS commands can be executed using the Extron DataViewer application available from
www.extron.com. The host computer issuing the commands can be connected via the
following connections:
•
•
•
Connection Options
Host-to-Device Communications
Using the Command and Response Tables
SIS Commands
Hardware Reset Modes
Command and Response Table
Object ID (OID) Number Tables
Troubleshooting
RS-232 Port
AT Port
USB Config Port
NetPA U 2002 SB User Guide • Remote Control and Communication
Rear Panel Features on page 17 for details on the
on page 27).
85