Extron electronics NetPA Ultra Series User Manual page 103

Group Masters
Command ASCII command
NOTES:
• For information on configuring groups, see
A group must have assigned members for these commands to have an effect.
•
X1*
• For , a positive (+) value is assumed unless a negative (-) value is specified.
X1^
• If entering an ,
with:
For gains:
The maximum upper/lower range of the soft limit or maximum upper/lower range of the group.
For mutes: E13 error (invalid parameter)
X1^ X1& X1*
, , , and
Set Group
Set Soft Limits
E
View Soft Limits
E
Set +/- dB
E
Set Mute
E
Increment
E
Decrement
E
View master value
E
Key:
X1$ Group number 1 – 32.
Soft limit High value
X1^
X1& Soft limit Low value
Group master value [For gain value with a resolution to 0.1, multiply by 10. For mute values, use 0 or 1.
X1*
X2) Increment or decrement value. [For gain value with a resolution to 0.1, multiply by 10. For mute values, use 0 or 1.]
Groups
X1& X1*
, or value outside the valid range for the group or outside the soft limits, the amplifier responds
X2)
values can be sent without leading zeroes.
X1$ X1^ X1& }
L * * GRPM
X1$ }
L GRPM
X1$ X1* }
D *+/- GRPM
X1$ X1* }
D * GRPM
X1$ X2) }
D * +GRPM
X1$ X2) }
D * -GRPM
X1$ }
D GRPM
Unit Response
on page 100
X1$ X1^ X1&]
GrpmL * *
X1^ X1&]
*
X1$ X1*]
GrpmD *
X1$ X1*]
GrpmD *
X1$ X1*]
GrpmD *
X1$ X1*]
GrpmD *
X1*]
NetPA U 2002 SB User Guide • SIS Command and Response
Unit Response: Verbose 2/3
X1$ X1^ X1&]
GrpmL * *
X1$ X1*]
GrpmD *
96