Related Manuals for Extron electronics DTP HD DA 4K Series
Summary of Contents for Extron electronics DTP HD DA 4K Series
- Page 1 User Guide Video Products DTP HD DA 4K Series DTP HDMI Distribution Amplifier 68-2545-01 Rev. G 03 22...
- Page 2 Safety Instructions...
- Page 3 Copyright www.extron.com © 2019-2022 Extron. All rights reserved. Trademarks All trademarks mentioned in this guide are the properties of their respective owners. The following registered trademarks( ® , registered service marks( ), and trademarks( ) are the property of RGB Systems, Inc. or Extron (see the current list of trademarks on the page at Terms of Use...
- Page 4 FCC Class A Notice This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. The Class A limits provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
- Page 5 Conventions Used in this Guide Notifications The following notifications are used in this guide: CAUTION: Risk of minor personal injury. ATTENTION : Risque de blessure mineure. ATTENTION: • Risk of property damage. • Risque de dommages matériels. NOTE: A note draws attention to important information. Software Commands Commands are written in the fonts shown here: ^AR Merge Scene,,0p1 scene 1,1 ^B 51 ^W^C.0...
-
Page 7: Table Of Contents
Tabletop Use ..........32 Error Responses ..........13 Mounting Kits ..........32 EDID .............. 13 DTP HD DA 4K Series EDID Memory Locations ............14 Command and Response Table for SIS Commands ............15 Extron DTP HD DA 4K Series • Contents... - Page 8 Extron DTP HD DA 4K Series • Contents viii...
-
Page 9: Introduction
• DTP outputs are compatible with HDBaseT‑enabled devices — Each DTP output can be configured to send video and embedded audio, plus bidirectional RS-232 and IR signals to an HDBaseT-enabled device. Extron DTP HD DA 4K Series • Introduction... - Page 10 HDMI input loop‑through — The DTP HD DA 4K series features an active local HDMI • output for local monitor support or system expansion. Audio input with loop‑through accepts additional analog stereo audio • signals — The DTP HD DA 4K series accepts stereo analog audio signals for simultaneous transmission over the same shielded twisted pair cable, and it includes a loop-through for local audio system and monitoring needs.
-
Page 11: Application Diagrams
Application Diagrams The following diagrams show typical applications for the DTP HD DA 4K series. Extron Tablet Laptop Laptop Laptop TLP Pro 320C 3.5" Cable Cubby iPad TCP/IP TouchLink Pro Network LAPTOP DISPLAY ON Touchpanel Combined Combined DISPLAY OFF MUTE... -
Page 12: Installation And Operation
Installation and Operation This section details the installation and operation of the DTP HD DA 4K series of distribution amplifiers including: • Rear Panel Features • Front Panel Features • Connection Details Rear Panel Features 100-240V 1.0A DTP HD DA4 330... - Page 13 Tx Rx G Tx Rx IR Device Tx/Rx Pins RS-232 Device Figure 4. RS‑232 and IR Wiring for the Over TP Port NOTE: RS-232 and IR data can be transmitted simultaneously. Extron DTP HD DA 4K Series • Installation and Operation...
-
Page 14: Front Panel Features
Output Signal LEDs — Light green when a signal is detected on the HDMI outputs. Output HDCP LEDs — Light green when HDCP presence is detected on the HDMI outputs. Extron DTP HD DA 4K Series • Installation and Operation... -
Page 15: Connection Details
Limit the use of more than two pass-through points, which may include patch points, punch down connectors, couplers, and power injectors. If these pass-through points are required, use shielded couplers and punch down connectors. Extron DTP HD DA 4K Series • Installation and Operation... -
Page 16: Tp Cable Termination For Ethernet Communication
Neither port has precedence and commands from either port are handled in the • order they are received. • Extron recommends that the USB port is used for temporary connections. If a permanent connection is required, the RS-232 port should be used. Extron DTP HD DA 4K Series • Installation and Operation... -
Page 17: Lockit Hdmi Lacing Bracket Installation
Computer DTP HD DA 4K Figure 8. Wiring the DTP HD DA 4K Series for RS‑232 Control LockIt HDMI Lacing Bracket Installation The Extron LockIt lacing brackets make it possible to simply and universally secure a standard HDMI cable to most HDMI devices. -
Page 18: Sis Configurations And Control
SIS Configurations and Control Use SIS commands to configure the DTP HD DA 4K series. This section provides information about using those commands. Topics include: • Introduction to SIS • Using the Command and Response Table • Command and Response Table for SIS Commands... -
Page 19: Using The Command And Response Table
DTP HD DA 4K Series EDID Memory Locations on page 14. EDID data as 256 bytes of hex data (text representation) Native resolution and refresh Example: 1600x1200 @ 60 Hz rate (translated from hex) Extron DTP HD DA 4K Series • SIS Configuration and Control... - Page 20 (255.255.0.0 = default) Password 12 digits and alphanumeric characters for user or admin passwords. Port number 01 = Remote RS-232/RS-422 port X5& 02 = unused 03-10 = UARTs 1 through 8 Extron DTP HD DA 4K Series • SIS Configuration and Control...
-
Page 21: Error Responses
A table showing the factory loaded EDID options is shown on the following page. The EDID memory location is labelled X$ for consistency with the value in the SIS commands. Extron DTP HD DA 4K Series • SIS Configuration and Control... -
Page 22: Dtp Hd Da 4K Series Edid Memory Locations
Extron DTP HD DA 4K Series • SIS Configuration and Control... -
Page 23: Command And Response Table For Sis Commands
= DVI = HDMI YUV 444 "Full" = HDMI RGB "Full" = HDMI YUV 422 "Limited" = HDMI RGB "Limited" = HDMI YUV 422 "Full" = HDMI YUV 444 "Limited" Extron DTP HD DA 4K Series • SIS Configuration and Control... - Page 24 4 (DTP HD DA4 models), or loop out to 8 (DTP HD DA8 models) = Set HDBT compatibility mode: = Normal DTP/HDBT operation (default) = Enable HDBT full compatibility mode Extron DTP HD DA 4K Series • SIS Configuration and Control...
- Page 25 Set DNS server IP address E X1^ X1^] Default = 0.0.0.0 View DNS server IP address X1^] Get number of connections {Number of connections} E X1( • X1(] Set admin password Extron DTP HD DA 4K Series • SIS Configuration and Control...
- Page 26 Configure global port X6$] Pti1* timeout View global port timeout X6$] Set UART start point E X6% X6%] Default = 1999 Output 1 uses 2001 Output 8 uses 2008 Extron DTP HD DA 4K Series • SIS Configuration and Control...
- Page 27 N 1 HDCP HdcpN 1 View HDCP notifications X6&] N HDCP X6&] HdcpN Verbose mode 2/3 KEY: X6& = View HDCP Notification = Green screen (default) = Black screen Extron DTP HD DA 4K Series • SIS Configuration and Control...
-
Page 28: Product Configuration Software
Product Configuration Software The DTP HD DA 4K series can be easily configured using Extron Product Configuration Software (PCS). This section describes the software installation and communication. Topics include: Software or Firmware Installation • • Connecting to PCS • Offline Device Preview Software Overview •... - Page 29 Double-click the executable file and follow the on-screen directions to install the software. For Firmware: To install via PCS, see Update Firmware on page 28. To install via internal webpage, see Firmware update on page 30. Extron DTP HD DA 4K Series • Product Configuration Software...
-
Page 30: Connecting To Pcs
Extron PCS window opens to the Device Discovery panel (see figure 14). Figure 14. Device Discovery Screen Select the DTP HD DA 4K device by clicking on it to highlight it in the list ( Click Connect ( Extron DTP HD DA 4K Series • Product Configuration Software... -
Page 31: Tcp/Ip Panel
), enter the port number or leave the field blank. PCS scans for the port if blank. TIP: Select the Show Characters checkbox ( ) to display the password characters. Click the Connect button ( ). A new device tab opens. Extron DTP HD DA 4K Series • Product Configuration Software... -
Page 32: Offline Device Preview
The New Configuration File dialog box opens (see figure 17). Figure 17. New Configuration File Dialog Box Select the desired device model from the Device Models list (see figure 17). Click Configure. A new offline device configuration tab opens. Extron DTP HD DA 4K Series • Product Configuration Software... -
Page 33: Software Overview
Show Expanded Device Tabs Selecting Show Expanded Device Tabs from the Software menu displays the device IP address or connection method in the Device tab. Figure 20. Expanded Device Tab Extron DTP HD DA 4K Series • Product Configuration Software... - Page 34 Click the Details button (figure 22, ) for more information. To display details about third-party software packages and associated licensing, click Licenses ( Click OK ( ) to close the dialog box. Extron DTP HD DA 4K Series • Product Configuration Software...
-
Page 35: Device Menu
Deploy Configuration to Device(s) — Upload a saved configuration to selected device(s) on the network. Disconnect — Disconnect the device from the PCS program and close the Device • tab. Extron DTP HD DA 4K Series • Product Configuration Software... - Page 36 Update Firmware to Multiple Device... — Upload firmware to multiple devices on the network. About This Module — Open the About This Module dialog box, with the module • part number and firmware version of the connected device. Extron DTP HD DA 4K Series • Product Configuration Software...
-
Page 37: Internal Web Page
The DTP HD DA 4K series feature an internal web server, displayed as a web page. This page allows you to monitor and adjust certain settings of the DTP HD DA 4K series via LAN connection. Use a web browser to view the pages on a PC connected to the device LAN port. -
Page 38: Web Page Panels
Web Page Panels The DTP HD DA 4K series internal web page (see figure 25) provides an overall, read-only view of the status of the DA, with some editable fields. Panels are: Output Status Date/Time Settings Panel Password Panel Input Status... -
Page 39: Date/Time Settings Panel
In the event of a complete system reset, the passwords convert to the default, which is extron. To assign passwords, click the Set button in the Password panel. Extron DTP HD DA 4K Series • Internal Web Page... -
Page 40: Equipment Mounting
• L’installation et l’entretien doivent être effectués par le personnel autorisé uniquement. The DTP HD DA 4K series of distribution amplifiers can be set on a table, mounted in a rack, or mounted under a desk or table. Tabletop Use... - Page 41 Mise à la terre — Assurez-vous que l’équipement est correctement mis à la terre. • Accordez une attention particulière aux connexions électriques autres que les connexions directes au circuit de dérivation (ex. : les multiprises). Extron DTP HD DA 4K Series • Equipment Mounting...
- Page 42 Extron Warranty Extron warrants this product against defects in materials and workmanship for a period of three years from the date of purchase. In the event of malfunction during the warranty period attributable directly to faulty workmanship and/ or materials, Extron will, at its option, repair or replace said products or components, to whatever extent it shall deem necessary to restore said product to proper operating condition, provided that it is returned within the warranty period, with proof of purchase and description of malfunction to: USA, Canada, South America,...