Adjustments; Testing; Lubrication; Servicing Information - BENDIXKing XVUE TOUCH Installation Manual

9.2.4.8 Adjustments

There are no adjustments or alignments required for maintenance of the KSD 100EXP, KCP 100EXP, and
the KTP 73.
Removing and replacing the KG 71EXP and or KMG 7010/MD32 requires compass calibration and airplane
leveling. Refer to Section 6.3 KG 71EXP Configuration (ADAHRS) and Section 6.4 KMG 7010/MD32
Calibration (Magnetometer).
If a new configuration module is installed, it will not include the existing data. Utilize the Restore Data To
APM feature within the Installer Menu to restore the settings within the new configuration module,
follow the procedures in Section 6.2.

9.2.4.9 Testing

No scheduled system maintenance testing is required.

9.2.4.10 Lubrication

There are no requirements for periodic lubrication of the xVue Touch System components.

9.2.5 Servicing Information

No scheduled servicing tasks are required on the xVue Touch System components.

9.2.6 Troubleshooting

Refer to Section 8 of this document for troubleshooting steps.
The xVue Touch System components are not field-repairable. Repairs must be made by a properly
certificated repair facility. Contact BendixKing Customer Service for details.

9.2.7 Storage Limitation

There are no storage limitations on the xVue Touch System components.

9.2.8 Removal and Reinstallation Information

9.2.8.1 Removal

9.2.8.1.1 KSD 100EXP Removal

BE SURE TO HOLD THE KSD 100EXP SUCH THAT THE GLASS DOES NOT REST AGAINST THE
AIRPLANE CONTROL COLUMN OR YOKE DURING REMOVAL AND INSTALLATION.
Execute the following steps for removal of the KSD 100EXP:
(1) Ensure all power is removed from the airplane.
(2) Remove the four socket head mounting screws from the front of the KSD 100EXP.
(3) Remove the KSD 100EXP from the instrument panel.
(4) Remove the ground stud nut and ground wire from the back of the KSD 100EXP, if installed.
(5) Disconnect the two DB-78 connectors, J1 and J2, from the back of the KSD 100EXP.
(6) Remove the eight #2-56 screws attaching the Santoprene™ Grip to the LCD mount.
(7) Unsnap the Santoprene™ Grip from the front edge of the LCD Mount and slide the grip towards
the back of the KSD 100EXP to remove.
89000109-002
Rev 2
© Honeywell International Inc. Do not copy without express permission of Honeywell.
For Use in Non-Certified Aircraft
NOTE
xVue Touch Installation Manual
Page 9-8