BENDIXKing XVUE TOUCH Installation Manual page 233

xVue Touch System
Component Description
KG 71EXP ADHARS A general visual inspection of the KG 71EXP
ADHARS and the associated wiring and Pitot
and Static lines must be performed during
each annual inspection. Visually check
wiring for general condition, routing,
chafing, bonding straps and/or wires and
integrity of clamping and stand-offs.
Visually check the mechanical installation
for condition, including checking the unit
and all mounting brackets for security.
Loose and chafing brackets will increase the
resistance between parts. Check for signs
that the units have not been tampered with
or removed. Inspect and verify the bonding
straps or ground wires are in good
condition, and are not loose or chafing.
Connection points to the units and to the
airframe must be inspected for evidence of
corrosion.
If any of these indications are present, an
electrical bonding test must be performed.
Within the preceding 24 calendar months,
each static pressure system, each altimeter
instrument, and each automatic pressure
altitude reporting system has been tested
and inspected and found to comply with
Appendices E and F of 14 CFR Part 43.
Connectors Check for general condition, and integrity of
the attachment hardware.
Circuit breakers Check for general condition and operation.
Switches Check for general condition and operation.
Associated wiring Check for general condition, routing,
chafing, and integrity of clamping and
stand-offs, and shields.
89000109-002
Rev 2
© Honeywell International Inc. Do not copy without express permission of Honeywell.
For Use in Non-Certified Aircraft
Table 9-1 ICA Inspection Criteria
Inspection Requirement
Recommended Minimum
Completed
Inspection Interval
12 months
24 months
12 months
12 months
12 months
12 months
xVue Touch Installation Manual
Page 9-7