Lightware MMX8x4-HT Series User Manual page 134


  
8. LW3 Programmers' Reference
USB Port Settings
USB Host Select
SET•/MEDIA/USB/USBSWITCH.HostSelect=<USB_host>
Ý
Power Switch Delay
SET•MEDIA/USB/USBSWITCH.DelayedSwitch=<delay_status>
Ý
Host 5V Sense
GET•/MEDIA/USB/USBSWITCH.<HostPc>
Ý
Device 5V Enable
Ý SET /MEDIA/USB/USBSWITCH.Device5vEnable1=<enable>
Query the 5V Overcurrent status of the Device
Ý GET /MEDIA/USB/USBSWITCH.<deviceid>
Ethernet Configuration
Query the Current IP Address
Ý GET•/MANAGEMENT/NETWORK.IpAddress
Query the Current DHCP Status
Ý GET•/MANAGEMENT/NETWORK.DhcpEnabled
Set a Dynamic IP Address
SET•/MANAGEMENT/NETWORK.DhcpEnabled=<dhcp_status>
Ý
Set a Static IP Address
SET•/MANAGEMENT/NETWORK.StaticIpAddress=<IP_address>
Ý
Change the Subnet Mask (Static)
SET•/MANAGEMENT/NETWORK.StaticNetworkMask=<netmask>
Ý
Change the Gateway Address (Static)
SET•/MANAGEMENT/NETWORK.StaticGatewayAddress=<gw_address>
Ý
Apply Network Settings
Ý CALL•/MANAGEMENT/NETWORK:ApplySettings(1)
Ethernet Message Sending
Sending a TCP Message (ASCII-format)
Ý CALL•/MEDIA/ETHERNET:tcpMessage(<IP_address>:<port_no>=<message>)
Sending a TCP Text (ASCII-format)
Ý CALL•/MEDIA/ETHERNET:tcpText(<IP_address>:<port_no>=<text>)
MMX8x4-HT series – User's Manual
Sending a TCP Binary Message (HEX-format)
Ý CALL•/MEDIA/ETHERNET.tcpBinary(<IP_address>:<port_no>=<HEX_message>)
Sending UDP Message (ASCII-format)
Ý CALL•/MEDIA/ETHERNET:udpMessage(<IP_address>:<port_no>=<message>)
Sending a UDP Text (ASCII-format)
Ý CALL•/MEDIA/ETHERNET:udpText(<IP_address>:<port_no>=<text>)
Sending a UDP Binary Message (HEX-format)
Ý CALL•/MEDIA/ETHERNET:udpBinary(<IP_address>:<port_no>=<HEX_message>)
System Monitoring Commands
Query Video Signal Presence
Ý GET•/MEDIA/VIDEO/<port>.SignalPresent
Query Connected Device (or Cable)
Ý GET•/MEDIA/VIDEO/<port>.Connected
Query Embedded Audio
Ý GET•/MEDIA/VIDEO/<port>.EmbeddedAudioPresent
Hotplug Detect
Ý GET•/MEDIA/VIDEO/<port>.Power5vIn
Query Audio Indicators for Microphone Input
GET•/MEDIA/AUDIO/I9.<sign_level>
Ý
Query Audio Indicators for Advanced Audio Ports
GET•/MEDIA/AUDIO/<advanced_port>.<sign_level><ch>
Ý
Query the Connection State of the Remote Device
Ý GET•/REMOTE/<port>.LinkState
Query Connected Device
Ý GET•/REMOTE/<port>.ConnectedDevice
Connected IP Address
Ý GET•/REMOTE/<port>.RemoteIpAddress
Applied firmware package: v1.2.2b5 | LDC software: v2.2.1
134