Lightware MMX8x4-HT Series User Manual page 45


  
5. Device Concept
Create a link towards the TPS input ports by connecting a patch cable between the two RJ45 connectors
(Ethernet Link to TPS inputs and TPS inputs Ethernet).
Create a link towards the TPS output ports by connecting a patch cable between the two RJ45 connectors
(Ethernet Link to TPS outputs and TPS outputs Ethernet):
Ethernet Link to TPS inputs
Ethernet Link to TPS outputs
Applied firmware package: v1.2.2b5 | LDC software: v2.2.1
MMX8x4-HT series – User's Manual
Ethernet Interface - Example
The concept
In the room 1. the Matrix reaches the LAN by connecting the Control Ethernet port to the Ethernet switch.
Creating a link between the RJ45 connectors labeled Ethernet Link to TPS inputs and TPS inputs Ethernet makes
possible to support TPS input ports (I1-4) with Ethernet.
In the room 2. a third-party Ethernet device connects to the TPS input port (I2). In this case, instead of TPS
data transmission the TPS connection provides only Ethernet connection to the LAN.
In the room 3. the TPS extender connects to the TPS input port (I4)of the Matrix. Besides the TPS data
transmission, the TPS extender provides connection to the LAN for e.g. a laptop.
Settings
Matrix: TPS modes in TPS input ports (I2, I4) can be set Auto. ETH Link TPS In (P4), TPS IN2 (P6), TPS IN4
(P8) can be enabled.
Ethernet and TPS Connectors for LAN
45