Connecting Steps - Lightware MMX8x4-HT Series User Manual


  
4. Installation
4.3. Connecting Steps
MMX8x4-HT400MC, MMX8x4-HT420M models
MMX8x4-HT series – User's Manual
CATx
HDMI
HDMI
Audio
Mic
Audio
USB
LAN
Relay
IR
GPIO
Power
*Only in MMX8x4-HT420M model.
Applied firmware package: v1.2.2b5 | LDC software: v2.2.1
Connect an HDBase-T -compatible transmitter or matrix output board to TPS input port.
TM
MMX8x4-HT400MC model is not PoE-compliant, and MMX8x4-HT420M model is PoE compliant.
Connect an HDMI source (e.g. PC) to the HDMI input port.
Connect an HDMI sink (e.g projector) to the HDMI output port.
Optionally for analog output: connect an audio device (e.g. audio amplifier) to the analog audio
output port by an audio cable.
Please read the Installation Guide for Connecting a Microphone
microphone to the matrix. Not proper setting could damage the device.
Optionally for audio input: connect the audio source (e.g. media player) to the audio input port
by an audio cable.
Optionally connect the USB cable in order to control the matrix switcher via Lightware Device
Controller software.
Optionally connect the UTP cable (straight or cross, both are supported) in order to control the
matrix switcher via the Lightware Device Controller software.
Optionally for relays: connect a controlled device(s) (e.g. a projection screen) to the relay port.*
Optionally connect the infra emitter to the infra output port (2-pole Phoenix or 1/8" Stereo Jack
connector) to transmit infra signal.
Optionally connect a controller/controlled device (e.g. button panel) to the GPIO port.*
Connect the power cord to the AC power socket to the matrix unit. It is recommended to power
on the devices as the final step.
32
section before connecting the