Lightware MMX8x4-HT Series User Manual page 17


  
2. Product Overview
MMX8x8-HDMI-4K-A
Sn:
HDMI OUT 1 HDMI
100-240 VAC
50/60 Hz 1.4-0.85A
HDMI IN 1 HDMI
Made in EU, Hungary
t
MMX8x8-HDMI-4K-A-USB20
1
t
w 5 6
I I R R O O U U T T 4 3 RS232
4 3 2 1
TX TX
OUT 2 HDMI OUT 3 HDMI OUT 4 HDMI OUT 5 HDMI OUT 6 HDMI OUT 7
IN 2 HDMI IN 3 HDMI IN 4 HDMI IN 5 HDMI IN 6 HDMI IN 7
r
#new
2 3 4 5 6
1
GPIO and USB 5V SUM max. 2A
r
MMX8x4-HT series – User's Manual
7 8 9 q
1
2 1
Reset
Boot
TX RX TX RX Control 2
ETHERNET
HDMI OUT 8
3
e
HDMI IN 8
4
5
6
7
7 8 9 q
8
9
w
q
e
w
e
r
t
Applied firmware package: v1.2.2b5 | LDC software: v2.2.1
Ethernet ports The two RJ45 connector for Ethernet (to control the unit or to pass-through).
They are in the same local network.
GPIO port 8-pole Phoenix connector for configurable general purpose
input/output ports.
USB-A ports The four USB 2.0 Type-A ports for connecting USB peripherals.
USB-B ports The four USB 2.0 Type-B ports for connecting USB hosts.
Infra output 3.5 mm TRS connectors (Jack plugs) for infra signal transmission.
ports
Serial/Infra 2-pole Phoenix connectors (2x) for IR output or TTL output serial signal.
output ports
RS-232 ports 3-pole Phoenix connectors (2x) for bi-directional RS-232 communication.
Reset button Reboots the matrix; the same as switching it off and on again.
Control Ethernet RJ45 connector to control the matrix via LAN. This is in the same local network
port with the other Ethernet ports.
Boot button Reset or power on the device while keep pushing the hidden button takes the
matrix in bootload mode.
HDMI output connectors for sink devices.
HDMI outputs
5-pole Phoenix connector for balanced analog audio; depending on the
Audio I/O ports
configuration, it can be input or output. Output audio is the de-embedded HDMI
signal from the nearby HDMI port.
HDMI inputs HDMI input ports (8x) for sources.
Standard IEC connector accepting 100-240 V, 50 or 60 Hz.
AC connector
17