Assemble The Sma/Flying Lead Test Connectors - Agilent Technologies 16902A Service Manual

Assemble the SMA/Flying Lead Test Connectors

The SMA/Flying Lead test connectors provide a high-bandwidth connection
between the logic analyzer and the test equipment. The following procedure
explains how to fabricate the four required test connectors.
Materials Required
Material
SMA Board Mount Connector
(Qty 8)
Pin Strip Header
(Qty 1, which will be separated)
SMA 50 ohm terminators
(Qty 2)
SMA m-m adapter
(Qty 4)
1 Prepare the pin strip header:
a Cut or cleanly break a 2 x 2 section from the pin strip.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Chapter 3: Testing Logic Analyzer Performance
Assemble the SMA/Flying Lead Test Connectors
Critical Specification
.100" X .100" Pin Strip
Header, right angle, pin
length .230", two rows, .120"
solder tails
Minimum bandwidth 2 GHz
Recommended Model/Part
Johnson 142-0701-801
(see
www.johnsoncomponents.com)
3M 2380-5121TN or similar 2-
row with 0.1" pin spacing
Johnson 142-0801-866 50 ohm
Dummy Load Plug
Johnson 142-0901-811 SMA
Plug to Plug or similar
23