[Pr. Pc15_Analog Monitor 2 Output (Mod2)]; [Pr. Pc16_Electromagnetic Brake Sequence Output (Mbr)]; [Pr. Pc17_Zero Speed (Zsp)]; [Pr. Pc18_Alarm History Clear (*Bps)] - Mitsubishi Electric MELSERVO-J5 Series User Manual

[Pr. PC15_Analog monitor 2 output (MOD2)]

Initial value
00000001h
[Pr. PC15.0-1_Analog monitor 2 output selection]
Initial value
01h
Select the signal to be outputted to analog monitor 2.
Refer to the following for setting values.
Page 64 [Pr. PC14_Analog monitor 1 output (MOD1)]

[Pr. PC16_Electromagnetic brake sequence output (MBR)]

Initial value
0 [ms]
Set the delay time used between the MBR (Electromagnetic brake interlock) shut-off and the base circuit shut-off.

[Pr. PC17_Zero speed (ZSP)]

Initial value
50 [r/min], [mm/s]
Set an output range of the zero speed signal (ZSP).
The zero speed signal detection has a hysteresis of 20 [r/min] (20 [mm/s]).

[Pr. PC18_Alarm history clear (*BPS)]

Initial value
00000000h
[Pr. PC18.0_Alarm clear history selection]
Initial value
0h
0: Disabled
1: Enabled
When "1" (enabled) is set, the alarm history will be cleared at the next power-on or software reset. After the alarm history is
cleared, "0" (disabled) will be set to this servo parameter automatically.
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
Setting range
0 to 1000
Setting range
0 to 10000
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
1.4 Extension setting servo parameters group ([Pr. PC_ _ ])
Ver.
Refer to the relevant detail No.
Ver.
A0
Ver.
A0
Ver.
A0
Ver.
Refer to the relevant detail No.
Ver.
A0
1 SERVO PARAMETER DETAILS
1
65