[Pr. Pf87_Drive Recorder - Analog Channel Setting 1 (Drac1)] - Mitsubishi Electric MELSERVO-J5 Series User Manual

[Pr. PF87_Drive recorder - Analog channel setting 1 (DRAC1)]

Initial value
00020201h
[Pr. PF87.0-2_Drive recorder - Analog channel 1 selection]
Initial value
201h
Select the data to be assigned to analog channel 1 of the drive recorder.
The servo parameter is disabled in the following conditions.
• [Pr. PF80.0 Drive recorder - Operation mode selection] = "0" (automatic setting mode)
Refer to the following table for setting values.
Values not listed below are undefined. Only set the values that are listed in the following table.
Setting value Data type
000 No assigned function
001 Servo motor speed
002 Torque/instantaneous torque
003 Current command
004 Command pulse frequency
005 Command pulse frequency (speed unit)
007 Droop pulses (1 pulse unit)
008 Speed command
009 Bus voltage
00C Effective load ratio
00D Regenerative load ratio
00E Position within one-revolution
00F ABS counter
010 Load to motor inertia ratio
011 Torque equivalent to disturbance
012 Overload alarm margin
014 Settling time
015 Overshoot amount
*2
01C Load-side encoder droop pulses (1 pulse unit)
*2
01E Motor-side/load-side position deviation (1 pulse unit)
*2
020 Motor-side/load-side speed deviation
021 Servo motor speed (unit of 0.1 r/min)
022 Command pulse frequency (speed unit of 0.1 r/min)
023 Speed command (unit of 0.1 r/min)
024 Torque command
025 Speed limit value
026 Speed limit value (unit of 0.1 r/min)
035 Internal temperature of encoder
03B Load-side encoder information 1
03C Load-side encoder information 2
049 Operation mode
*3
04C U-phase current feedback (unit of the rated current)
*3
04D V-phase current feedback (unit of the rated current)
*3
04E W-phase current feedback (unit of the rated current)
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
1.7 Extension setting 3 servo parameters group ([Pr. PF_ _ ])
Ver.
Refer to the relevant detail No.
Ver.
A0
*1
Unit Category
 
1 r/min 16-bit data
0.1 %
0.1 %
kpulse/s
1 r/min
1 pulse
1 r/min
1 V
0.1 %
0.1 %
16 pulses
1 rev
0.01 multiplier
0.1 %
0.1 %
1 ms
1 pulse
1 pulse
1 pulse
1 r/min
0.1 r/min
0.1 r/min
0.1 r/min
0.1 %
1 r/min
0.1 r/min
1 °C
16 pulses
1 rev
1LSB
0.1 %
0.1 %
0.1 %
1 SERVO PARAMETER DETAILS
1
127