[Pr. Pd24_Output Device Selection 2 (*Do2)]; [Pr. Pd25_Output Device Selection 3 (*Do3)]; [Pr. Pd26_Output Device Selection 4 (*Do4)] - Mitsubishi Electric MELSERVO-J5 Series User Manual

[Pr. PD24_Output device selection 2 (*DO2)]

Initial value
0000000Ch
Select a function of the CN3-23 pin.
If the absolute position detection system with DIO is selected while [Pr. PA03.0 Absolute position detection system selection]
has been set to "1" (enabled (absolute position detection system by DIO)), the CN3-23 pin functions as "ABS transmission
data bit 1 (ABSB1)" during the ABS transfer mode.
[Pr. PD24.0-1_Device selection]
Initial value
0Ch
Refer to the following for setting values.
Page 94 [Pr. PD23_Output device selection 1 (*DO1)]

[Pr. PD25_Output device selection 3 (*DO3)]

Initial value
00000004h
Select a function of the CN3-24 pin.
[Pr. PD25.0-1_Device selection]
Initial value
04h
Refer to the following for setting values.
Page 94 [Pr. PD23_Output device selection 1 (*DO1)]

[Pr. PD26_Output device selection 4 (*DO4)]

Initial value
00000007h
Select a function of the CN3-25 pin.
If the absolute position detection system with DIO is selected while [Pr. PA03.0 Absolute position detection system selection]
has been set to "1" (enabled (absolute position detection system by DIO)), the CN3-25 pin functions as "ABS transmission
data ready (ABST)" during the ABS transfer mode.
[Pr. PD26.0-1_Device selection]
Initial value
07h
Refer to the following for setting values.
Page 94 [Pr. PD23_Output device selection 1 (*DO1)]
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
Ver.
Refer to the relevant detail No.
Ver.
A0
Ver.
Refer to the relevant detail No.
Ver.
A0
Ver.
Refer to the relevant detail No.
Ver.
A0
1 SERVO PARAMETER DETAILS
1.5 I/O setting servo parameters group ([Pr. PD_ _ ])
1
95