[Pr. Pa05_Number Of Command Input Pulses Per Revolution (*Fbp)]; [Pr. Pa06_Electronic Gear - Numerator (Cmx)]; [Pr. Pa07_Electronic Gear - Denominator (Cdv)] - Mitsubishi Electric MELSERVO-J5 Series User Manual

[Pr. PA05_Number of command input pulses per revolution
(*FBP)]
Initial value
10000 [pulse]
The servo motor rotates once as per command input pulse that has been set.
The setting value of this servo parameter is enabled when [Pr. PA21.3 Electronic gear compatibility selection] is set to "1"
(number of command input pulses per revolution). In the linear servo motor control mode or fully closed loop control mode,
[Pr. PA21.3] cannot be set to "1".

[Pr. PA06_Electronic gear - Numerator (CMX)]

Initial value
1
Set the electronic gear numerator.
This servo parameter is enabled in the following condition: [Pr. PA21.3 Electronic gear compatibility selection] is "0" (electronic
gear), "2" (J3 electronic gear setting value compatibility mode), "3" (J2S electronic gear setting value compatibility mode), or
"4" (J4 electronic gear setting value compatibility mode).
The condition range of the electronic gear ratio is shown in the table below. If the set value is outside this range, noise may be
generated during acceleration/deceleration, or operation may not be performed at the preset speed and/or acceleration/
deceleration time constants. In addition, if the electric gear numerator exceeds "2147483647" by combining this servo
parameter and [Pr. PA21.3], the electric gear numerator is limited to "2147483647".
Encoder resolution [pulse]
67108864

[Pr. PA07_Electronic gear - Denominator (CDV)]

Initial value
1
Set the electronic gear denominator.
This servo parameter is enabled in the following condition: [Pr. PA21.3 Electronic gear compatibility selection] is "0" (electronic
gear), "2" (J3 electronic gear setting value compatibility mode), "3" (J2S electronic gear setting value compatibility mode), or
"4" (J4 electronic gear setting value compatibility mode).
Setting range
1000 to 1000000
Setting range
1 to 2147483647
Setting range (CMX/CDV)
1/10 < CMX/CDV < 64000
Setting range
1 to 2147483647
1.2 Basic setting servo parameters group ([Pr. PA_ _ ])
Ver.
A0
Ver.
A0
Ver.
A0
1 SERVO PARAMETER DETAILS
1
15