[Pr. Pc45_Function Selection C-A (**Copa)] - Mitsubishi Electric MELSERVO-J5 Series User Manual

[Pr. PC45_Function selection C-A (**COPA)]

Initial value
00000000h
[Pr. PC45.0_Encoder pulse count polarity selection]
Initial value
0h
Select a polarity of the linear encoder or load-side encoder.
0: Encoder pulse increasing direction in the servo motor CCW or positive direction
1: Encoder pulse decreasing direction in the servo motor CCW or positive direction
[Pr. PC45.2_ABZ phase input interface encoder ABZ phase connection assessment
function selection]
Initial value
0h
Select the non-signal detection status for the pulse train signal from the A/B/Z-phase input interface encoder used as a linear
encoder or load-side encoder.
This function is enabled when an A/B/Z-phase input interface encoder is used.
Setting value
0
1
1 SERVO PARAMETER DETAILS
80
1.4 Extension setting servo parameters group ([Pr. PC_ _ ])
Setting range
Refer to the relevant detail No.
Setting range
Refer to the text
Setting range
Refer to the text
Detection of disconnection
Z-phase-side non-signal
Enabled
Disabled
Ver.
Refer to the relevant detail No.
Ver.
A0
Ver.
A0
Alarm status
Linear
[AL. 020.6 Encoder normal communication - Transmission
data error 2] (Z-phase)
