Table of Contents
Advertisement
PRAESENSA
5.2.2
Add a device
With the exception of the initial added network device (system controller), no other
connected network devices are listed on the system composition page after using the
rediscover function. This means that you have to add and set each network device to the
system composition first. Only then the network device could be recognized, listed and
configured in the system. See Logon the application, page 35 , if required.
To do so:
1.
2.
3.
4.
5.
6.
7.
8.
Notice!
If an added device is disconnected from the PRAESENSA network afterwards, the Hostname
will be colored "light grey" only after using the Rediscover function and upon entering the
web page. Besides that a lost device fault event messages is generated.
Bosch Security Systems B.V.
Click the Add button:
–
An Adding row appears.
Enter the device Name in the text box:
–
The name may consist of up to 32 characters.
Select the Device type from the dropdown list:
–
The Device type name (e.g. PRA-AD608 is part of the Amplifier category) is fixed and
cannot be changed by the user.
Click the Add button below the row, or click the Cancel button to return:
–
By using the Add button, the device, including the unique Device hostname, will be
added to the System composition.
–
When Add a System client device, you will be asked to enter the IP‑address.
Select an unused device hostname from the Host name dropdown list:
–
The device hostname consists of an extraction of the commercial type number name
and the last 6‑digits of the MAC‑address. The device hostname is fixed and cannot be
changed by the user. Refer to the label on the device. See Logon the application,
page 35 , if required.
–
When you select an already used device hostname, a prompted message will ask you
to select another (unused) one, as soon you click the Submit button.
–
When you select unknown no device (type) will be linked because the correct
hostname is not selected.
–
If not already done, select the device hostname of the initially added network device
(system controller) from the Host name dropdown list.
Optional enter the Location (free text) name in the text box:
–
This could be e.g. the name of the physical location of the network device.
Click the Submit button:
–
Notice that the changes are not permanent until the configuration is saved. See Save
configuration, page 102 .
Only after Save configuration and restart system, the function of Show identification
checkbox can be activated. Enable (checkmark/on) the checkbox or disable (off) the
Show identification checkbox if you (not) want to visualize identification of the selected
network device:
–
By enabling, the LEDs of the network device front/top (and rear) panel will be
immediately switching intermittent on and off as long Show identification is enabled.
–
Disable the checkbox to stop the network device (LED) identification.
Configuration manual
Configure the system | en
2020-09 | V1.20 | PRAESENSA 1.20
41
Advertisement
Table of Contents
