Table of Contents
Advertisement
124 en | Optional: Using the Logging Server
11.6
Security
On the Security tab, the security settings can be defined.
Server authentication
Use the controls in the Server authentication block to:
–
–
Viewer/Network controller authentication
Use the controls in the Viewer/System controller authentication block to set the password and
user name that:
–
–
Note: Make sure that all systems have an account that contains the user name and password
in the Viewer/System controller block. Otherwise, the Logging Server cannot connect to the
systems.
2020-09 | V1.20 | PRAESENSA 1.20
–
Notice: When the database is flushed and the Logging Server is started again, the
database is filled with the events that are retrieved from the enabled system
controllers. Each enabled system controller keeps an internal list of up to 1000
events per category.
Enable and disable server authentication with the Use authentication box. When server
authentication is enabled, a user name and password must be entered to get access to
the main window.
Set the password and user name to get access to the Logging Server with the Change
User Name/Password button. A password and user name can only be set when server
authentication is enabled. The password must have at least five (5) characters. The user
name must have at least four (4) characters.
Gives a Logging Viewer access to the Logging Server.
Gives the Logging Server access to all connected system controllers.
Configuration manual
PRAESENSA
Bosch Security Systems B.V.
Advertisement
Table of Contents
