Table of Contents
Advertisement
36
en | Logon the application
6.
7.
8.
9.
10. Click the Submit button:
11. Proceed with: Configure the system, page 37 .
2020-09 | V1.20 | PRAESENSA 1.20
–
PRAESENSA is default set for using a secured connection between the system
controller and other network devices.
–
An initial user account automatically gets the secured configuration administrator
rights.
–
Deleting the Initial (administrator) setup user account can only be done by adding a
new user account with administrator rights and then delete the initial one. See User
accounts, page 38 .
st
Only at 1
/ initial logon > a OMNEO security username and OMNEO passphrase is
automatically generated by the system controller:
–
You need this security username and passphrase for a secure firmware upload.
–
If required, see Change user name and passphrase, page 113 .
Click the Create button > A web browser page appears, showing the following elements:
–
On top of the web browser page, from left to right: the name of the device (system
controller), your username and the software release number. See (Mandatory)
software, page 16 ).
–
The name of, and link to, the system controller.
–
Configure - A button that opens the configuration items selection.
–
Diagnose - A button that opens the diagnostics items selection.
–
Security - A button that opens the system Security and Open Interface item selection
(e.g. download certificate).
–
Print configuration - A button that opens the configuration printing utility.
–
About - A button that opens the Open source licenses.
–
Main frame - A frame that displays the selected PRAESENSA web browser page.
–
Home - A button that returns to the Home web browser page where you could select:
- The (new) language and the continue button.
–
Logout - A button which returns you to the logon webpage. You have to logon the
configuration again, if required.
Click the Home button to select/change a language for the webserver GUI and web
browser pages and click the continue button to access the web browser pages in the
selected language.
Select and click the system controller name/link:
–
On default the system controller device hostname is selected and fixed. If not, select
the system controller device hostname from the Host name dropdown list.
Notice that the changes are not permanent until the configuration is saved. See Save
–
configuration, page 102 .
Configuration manual
PRAESENSA
Bosch Security Systems B.V.
Advertisement
Table of Contents
