Action Definitions; Assigning An Operation - Bosch PRAESENSA PRA-SCL Configuration Manual

84 en | Configure the system
5.7

Action definitions

On the Action definitions pages specific device functionality can be configured, e.g. the
buttons of the call station (extension), control inputs of the multifunction power supply and
the virtual control inputs of the system controller.
The process of configuring an action to a button or control input consists of two steps:
1.
2.
See the following sections to configure the actions per device type category:
–
–
–
5.7.1

Assigning an operation

The operation specifies how the control input deals with incoming signals or how the button
reacts when it is pressed and released. An operation is always linked to a function (see
Assigning a function, page 85 ).
Type of operations
The available type of operations are represented in the following table:
Operation type
Momentary - abort on release
Momentary - finish on release
Toggle - abort on switch off
Toggle - finish on switch off
Do once
2020-09 | V1.20 | PRAESENSA 1.20
Assigning an operation, page 84
Assigning a function, page 85
System controller, page 92
Multifunction power supply, page 93
Call station, page 94
Description
The action coupled to the control input or button is
active during the time the external contact is closed.
When the external contact is opened, the action is
immediately aborted.
The action coupled to the control input or button is
active during the time the external contact is closed.
When the external contact is opened, the action is
stopped after the completion of the current phase.
When the external contact is closed again while the
action is still running, the action is immediately aborted.
The action coupled to the control input or button is
started when the external contact closes and
immediately aborted when the external contact closes
again.
The action coupled to the control input or button is
started when the external contact closes. When the
external contact closes again, the action is stopped after
the completion of the current phase.
When the external is closed a third time while the action
is still running, the action is immediately aborted.
The action is started when the external contact closes.
The action can be stopped with an Abort phased
announcement or Finish phased announcement.
Usually, the Abort/Finish phased announcement
Configuration manual
PRAESENSA
Bosch Security Systems B.V.