Bosch PRAESENSA PRA-SCL Configuration Manual page 140

140 en | Event messages
–
–
–
–
–
–
–
–
–
–
–
–
Only routing that is part of the call (announcement) is logged.
Event: CallTimeout
Group: Call
Occurrence: Logs the time‑out of a (stacked) call.
Originator: The system controller as device
Extra information: List of zones that did not receive this call completely.
General device events
Event: Emergency state acknowledge
Group: General
Occurrence: Logs acknowledge of the evacuation alarm.
Originator: Device, control input or Open Interface client that acknowledged the alarm.
Event: Emergency state reset
Group: General
Occurrence: Logs the reset of the evacuation alarm.
Originator: Device, control input or Open Interface client that reset the alarm.
Event: Emergency state active
Group: General
Occurrence: Logs the set/start of the evacuation alarm.
Originator: Device, control input or Open Interface client that set the alarm.
Event: Unit connect
Group: General
Occurrence: Logs the connection of a device.
Originator: Device that connected.
Extra information: Not available on Open Interface clients.
2020-09 | V1.20 | PRAESENSA 1.20
number of times the message(s) of the call should be repeated
whether or not there was live speech in the call
name of the audio input used for live speech (if applicable)
name(s) of the end tone/message(s) of the call
name(s) of the output(s) of the call
For a replay call:
reference to the original call id
call definition name used for the call
priority of the call
routing scheme (always non-partial for the monitor replay phase and partial or non-
partial for the broadcast replay phase).
timing scheme (always immediate)
name(s) of the output(s) of the call
Configuration manual
PRAESENSA
Bosch Security Systems B.V.