Table of Contents
Advertisement
134 en | Event messages
18
Event messages
Each event message generated by the PRAESENSA system belongs to an event group.
PRAESENSA has three event groups: General, Call and Fault.
Be noticed that events (descriptions) could be changed/removed and/or new ones could be
added to the PRAESENSA system. Therefore; the PRAESENSA Logging Server and Logging
Viewer applications are leading instead of the events described in this configuration manual.
General events
General events contain information about special situations. For example, the connection of a
device to the PRAESENSA system.
Call events
Call events contain information about calls/announcements in the PRAESENSA system. For
example, the start of a call/announcement.
Fault events
Fault events contain information about faults/errors in the PRAESENSA system and/or device.
For example, an overload of an amplifier output and/or malfunctioning of a device.
General system and device event messages
The event messages which PRAESENSA could generate are divided in:
–
–
All events are logged by the system controller and are available for the Logging Server,
Logging Viewer and Open interface (see: Optional: Using the Logging Server, page 120 ,
Optional: Using the Logging Viewer, page 125 , Optional: Using the Open Interface, page 132 .
See also Diagnose, page 105 .
Notice!
If the function "Clear event logging on restart" is enabled, all events are erased after restart of
the system (controller). See Save configuration, page 102 .
Event information
Depending on the event group and type, the following information is given:
Event (type): describes the event name (e.g. Call start).
Group: describes the group to where the event belongs to (General, Call or Fault).
Occurrence: describes the event and when the event occurs.
Originator: describes from which device and/or where the event can occur.
Resolve: describes when the event is resolved (only for fault events).
Extra information: extra information available in the event.
Note: special properties of an event (if applicable).
Recommended action: describes the action(s) to be taken by the user.
Aggregate to zone fault: Specifies if the fault must be aggregated to a zone fault (is
reflected in the zone fault status). If not specified then no aggregation to zone fault status
shall be done. Zone fault aggregation is done to the following fault types: 'open', indicating
an open line fault and 'other', indicating a short.
Aggregate to main power fault: Specifies if the fault must be aggregated to a main power
fault. If not specified then no aggregation to main power fault status shall be done.
Aggregate to backup power fault: Specifies if the fault must be aggregated to a backup
power fault. If not specified then no aggregation to backup power fault status shall be done.
2020-09 | V1.20 | PRAESENSA 1.20
General system events, page 137
Device specific events, page 145
Configuration manual
PRAESENSA
Bosch Security Systems B.V.
Advertisement
Table of Contents
