Table of Contents
Advertisement
110 en | Diagnose
6.4
Amplifier spare channel
The Amplifier spare channel page in the Diagnose section is used to generate a fault in an
amplifier output channel to force it to the spare output channel of the selected amplifier.
This function can be used to test the sparing and faults behavior in an installation (e.g. during
commissioning and/or certification of an installation).
The following information is presented on the Amplifier spare channel page:
Item
Name
Faulty channel
Apply
Notice!
To deactivate the spare channel switching: select "None" below Faulty channel, click the
corresponding Apply button, and acknowledge and reset the fault (See Assigning a function,
page 85 > acknowledge and/or reset).
Refer to
–
–
–
2020-09 | V1.20 | PRAESENSA 1.20
Description
Shows the name of each amplifier added to the system. See Add a
device, page 41 .
Click and select the (faulty) amplifier channel which need to be forced
routed via the spare amplifier channel. See Amplifier, page 48 .
Click the Apply button to set and activate the forced spare channel
switching of the selected amplifier (channel) in the system. See
Amplifier, page 48 > Front and rear panel indicators.
Add a device, page 41
Amplifier, page 48
Troubleshooting, page 133
Configuration manual
PRAESENSA
Bosch Security Systems B.V.
Advertisement
Table of Contents
