PRAESENSA
5.10
Backup and restore
On the Backup and Restore pages, the configuration parameters could be backup/restored on
a externally (PC) location you prefer. To do so, see:
–
–
5.10.1
Backup
To be sure that your configuration is not lost if it becomes e.g. corrupt, or when your system
controller is replaced, it is advisable to make a backup so it can be restored afterwards.
–
Backup your configuration file
See Logon the application, page 35 .
Proceed as follows:
1.
2.
3.
4.
5.
6.
7.
Refer to
–
Bosch Security Systems B.V.
Backup, page 103
Restore, page 104
IMPORTANT: Notice that recorded messages are not part of the backup
configuration .tar.gz file:
–
Be sure that the used recorded messages are stored on a safe place and that they
possible need to be uploaded again after restoring the configuration file. This step is
only needed in case the system controller is/was reset to default and/or replaced.
See also Recorded messages, page 68 .
Below the Backup and restore configuration page, click Backup:
–
A screen appears with the following items, to:
Enable (checkmark) the Configuration settings checkbox:
–
All already submitted and saved configuration settings will be selected to backup to
a location on your connected configuration computer.
Enable (checkmark) User credentials and certificates:
–
User credentials will be selected to backup, but also certificates will be done.
Enter your (new) Password in the text field (minimum 8 characters):
–
Notice that the password used for the backup could be different from the one used
for logon the configuration.
Click the Create button:
–
A .tar.gz backup file will be created.
–
Depending on the web browser type (e.g. Firefox, Edge, etc.) a save/open file
selection screen will appear.
Depending on the web browser type, browse to the file location where you want to store
the backup file:
–
The configuration and credentials selected will be stored on the location you
selected.
If required, see Restore, page 104 .
Recorded messages, page 68
Configuration manual
Configure the system | en 103
2020-09 | V1.20 | PRAESENSA 1.20