Door Array; Door Override; Output Properties; Output Name - Bosch solution 6000 Installation Manual

5) When finished press [OK] or [MENU] to exit.
Outputs > Commands >

Door Array

This menu allows the master user and installer to view
door status of the doors in groups of 16. Doors will
continuously be updated during the display so that real
time status can be seen. The top two rows of the display
show the door number, the third row displays the door
status
L = Door Locked
U = Door Unlocked
O = Override
- = Disabled or Not Available
1) Enter [MENU] + [4] + [0] + [4] and use the up and
down arrows to select the door group to view. The
keypad will display the following output array
information for outputs 1 to 16.
0000000001111111
1234567890123456
LLLLL---UUUUO---
Press  OK or MENU
In the above example screen,
L = Doors 01 to 05 are Locked
O = Door 13 has a Override condition
U = Doors 09 to 12 area Unlocked
- = Doors 06 to 08 and Doors 14 to 16 are Disabled or
Not Available
2) When finished press [OK] or [MENU] to exit.
Outputs > Commands >

Door Override

This menu allows you to manually override a door in the
event you wish to place the door in a manually open or
closed condition.
The first state is to select the door which you wish to
override keeping in mind that you will only be presented
with a list of doors that you are authorised to access and
secondly, that you are a master code holder.
1) Enter [MENU] + [1] + [0] + [1].
2) Use the arrow keys to highlight the door you wish
to override, then press [OK].
Bosch Security Systems 07/14 BLCC610I
-
  MENU 4-0-4
-
MENU 4-0-5
 
Solution 6000
Installation Manual

Dr1 Door 1 Name
Dr2 Door 2 Name
Dr3 Door 3 Name

Press OK or MENU
3) Use the [ON] and [OFF] keys to override the door
and toggle the door open or close, then press [OK].
To abort press [MENU].
Door 1 Name Dr1
Door Override is OFF,
To turn ON, Press ON.
To Go Back, Press OK
O U T P U T P R O P E R T I E S
Outputs > Properties >

Output Name

O u t p u t 1
This menu allows you to program the name for each
output. Output names can be up to 16 characters long.
1) Press [MENU] + [4] + [1] + [0] and use the up and
down arrows to highlight the Output in the list
then press [OK]. Alternatively, you can enter the
output number directly and press [OK].
2) Use the arrow and number keys to move and
change text. When the Output Name is complete,
press [OK]. At any time you can press the [OFF] key
to clear the text from the current cursor position to
the end of the line. .
Output Name Op1
External Siren
Press  OK to SAVE
See Alpha Text Programming in Section 4 —
i
Programming Overview for further detail on entering
Note
alpha text.
Outputs > Properties >

Event Type

This menu allows you to set the output event type. See the
Output Event Type Table and Event Type Descriptions in
this section for more information on the available options.
1) Press [MENU] + [4] + [1] + [1] and use the up and
down arrows to highlight the Output in the list
then press [OK]. Alternatively, you can directly
enter the output number and press [OK].
Output Programming

-
MENU 4-1-0
 
N a m e
 MENU 4-1-1
0 0 0
8-3