INVT Goodrive 300 Operation Manual page 84

inverters
Goodrive300
Functi
on Name
code
Switch-on
P05.14 delay of S1
terminal
P05.15 Switch-off
Detailed instruction of parameters
is natural closed.
3:3-wire control 2; Sin is the enabling terminal on
this mode, and the running command is caused by
SB1 or SB3 and both of them control the running
direction.NC SB2 generates the stop command.
Note: for the 2-wire running mode, when FWD/REV
terminal is valid, the inverter stop because of the
stopping command from other sources, even the
control terminal FWD/REV keeps valid; the inverter
won't work when the stopping command is
canceled. Only when FWD/REV is relaunched, the
inverter can start again. For example, the valid
STOP/RST stop when PLC signal cycles stop,
fixed-length stop and terminal control (see P07.04).
The function code defines the corresponding delay
time of electrical level of the programmable
terminals from switching on to switching off.
83
Function codes
Default Modif
value y
○
0.000s
○
0.000s