2.2 Connecting the power supply to a B&R device
Danger!
The voltage supply to the B&R device must be completely disconnected. Before connecting the power
cable, it is important to make absolutely sure that it has been disconnected from the power source
(e.g. power supply).
1. Touch the housing or ground connection in order to discharge any electrostatic charge from your body.
2. Connect the power supply connector to the B&R device and tighten the fastening screws (max. tightening
torque 0.5 Nm).
Panel PC 2100 user's manual V1.11
Figure 95: Connecting the power supply connector to a B&R device
Installation • Connecting to the power mains
173