Table of Contents
Advertisement
Product ID
Interfaces
POWERLINK
Quantity
Transmission
Type
Design
Transfer rate
Cable length
CAN
Quantity
Design
Transfer rate
Terminating resistor
Type
X2X
Type
Quantity
Design
Electrical characteristics
Power consumption
Environmental conditions
Temperature
Operation
Storage
Transport
Relative humidity
Operation
Storage
Transport
Mechanical characteristics
Weight
1)
More information is available in the Automation Studio help system (Communication - POWERLINK - General information - Hardware - IF / LS).
2)
CAN1: Electrically isolated.
CAN2: Not electrically isolated
3)
The terminating resistor can only be enabled/disabled for the CAN1 interface.
3.5.1.3.1 POWERLINK interface - Pinout
The POWERLINK interface on the system unit is referred to as IF1.
Cabling
Cable length
Status LED
Green
Link LED
Yellow
Link (POWERLINK net-
work connection available)
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering may differ from that used by
the particular operating system.
2)
This interface is referred to as IF1 in Automation Studio / Automation Runtime.
Panel PC 2100 user's manual V1.11
Table 98: 5ACCIF01.FPCC-000 - Technical data
POWERLINK - IF1
S/STP (Cat 5e)
Max. 100 m (min. Cat5e)
On
Off
See Status/Error LED.
On
Off
Activity (blinking - da-
ta transfer in progress)
Table 99: 5ACCIF01.FPCC-000 - POWERLINK interface
Technical data • Individual components
5ACCIF01.FPCC-000
1
100BASE-TX
Type 4
1)
Shielded RJ45
100 Mbit/s
Max. 100 m between two stations (segment length)
2
10-pin, male
2)
Max. 1 Mbit/s
Can be enabled or disabled using a sliding switch
X2X Link master
1
10-pin, male, electrically isolated
2 W
-20 to 55°C
-20 to 60°C
-20 to 60°C
5 to 90%, non-condensing
5 to 95%, non-condensing
5 to 95%, non-condensing
25 g
1)2)
1
Link LED
3)
RJ45, female
Status LED
123
Advertisement
Table of Contents
