Mounting An Automation Panel 1000 With Retaining Clips - B&R Panel PC 2100 User Manual

Installation • Installation

1.3 Mounting an Automation Panel 1000 with retaining clips

The Panel PC 2100 with AP1000 display unit is installed in the cutout using retaining clips. The number of retaining
clips depends on the display unit.
The following Automation Panel 1000 display units are mounted using retaining clips:
• 5AP1120.0573-000
• 5AP1151.0573-000
• 5AP1120.0702-000
• 5AP1120.1043-000
• 5AP1180.1043-000
• 5AP1120.156B-000
The thickness of the wall or cabinet plate must be between 1 mm and 6 mm.
A 2.5 mm hex socket screwdriver is needed to tighten and loosen the screws on the retaining clips. The maximum
tightening torque for the retaining clips is 1 Nm.
Devices must be installed on a flat, clean and burr-free surface; uneven areas can cause damage to the display
when the screws are tightened or the intrusion of dust and water.
Procedure
1. Check whether the included mounting screws are screwed into the retaining clips. If not, then the mounting
screws must be screwed into the retaining clips with a 2.5 mm hex key screwdriver. The mounting screws
only need to be screwed in far enough that they no longer protrude above the retaining clip.
2. Insert the device into the front side of the smooth, flat installation cutout. The dimensions for the cutout can
be found in Tab. 12 "AP1000 display units with retaining clips - Installation diagrams" on page 23.
3. Install the retaining clips on the device. This is done by inserting the clips into the openings on the sides
of the device (indicated by the orange circles). The number of retaining clips may vary depending on the
display unit. The exact number can be found in Tab. 12 "AP1000 display units with retaining clips - Installation
diagrams" on page 23.
166
Mounting screws
Figure 86: Preparing the retaining clips
Figure 87: Inserting the retaining clips
Retaining clip
Panel PC 2100 user's manual V1.11