Led Status Indicators - B&R Panel PC 2100 User Manual

2.4.9 LED status indicators

LED status indicators are located on the bottom of the PPC2100 between the ETH2 interface and the power button.
The following timing is used for the LED status indicators:
Block size: 250 ms
Repeat interval: 500 ms, 2 boxes thus represent one interval
LED Color Status
Power Green On
Red On
Red/Green Blinking
CFast Yellow On
Link Yellow On
Blinking
Run Green Blinking
Green On
Red On
Blinking
Panel PC 2100 user's manual V1.11
Power LED
CFast LED
Link LED
Run LED
Function
Voltage supply OK
System in standby mode (S5: Soft-off mode or S4: Hibernation
mode suspend-to-disk)
Faulty or incomplete BIOS, MTCX or I/O FPGA update, voltage
supply OK
Faulty or incomplete BIOS, MTCX or I/O FPGA update, stand-
by mode (S5: Soft-off mode or S4: Hibernation mode sus-
pend-to-disk)
Indicates CFast access
Indicates an active SDL connection on the male panel connec-
tor
Indicates that an active SDL connection has been interrupted
by a loss of power to the display unit
Information:
Check the voltage supply / power connector of the
connected display unit.
Automation Runtime booting
Controlled by Automation Runtime (ARemb and ARwin)
Application running
Controlled by Automation Runtime (ARemb and ARwin)
Application in service mode
Controlled by Automation Runtime (ARemb and ARwin)
Indicates a licensing violation
Table 44: LED status indicators - Data
Technical data • Complete system
LED status indicators
47