Replacing The System Unit - B&R Panel PC 2100 User Manual

1.6 Replacing the system unit

1. Disconnect the power supply to the Panel PC (disconnect the power cable). Isolate the system from all
potential sources of electrical power!
2. Discharge any electrostatic charge on the ground connection.
3. Remove the Panel PC from the control cabinet by following the installation steps in reverse order.
4. Place the Panel PC on a clean, flat surface.
5. Remove the Torx screws (T10) indicated in the following image.
6. The system unit can now be removed by pulling it straight up.
7. The system unit can now be replaced by following these steps in reverse order. The maximum tightening
torque of the Torx screws (T10) is 0.5 Nm.
Only the mounting materials included in delivery are permitted to be used to install the system unit.
Panel PC 2100 user's manual V1.11
Figure 91: Removing the Torx screws
Figure 92: Removing the system unit
Installation • Installation
171