Table of Contents
Advertisement
3. Install the retaining clips on the device. This is done by inserting the clips into the openings on the sides of
the device (indicated by the orange circles). The number of retaining clips may vary depending on the display
unit. The exact number can be found in Tab. 11 "Installation diagrams - AP9x3 display units" on page 22.
4. Fasten the retaining clips to the wall or control cabinet by alternately tightening the screws with a 2.5 hex key
screwdriver. The tightening torque should be max. 1 Nm to provide an optimal seal.
Control cabinet plate
Panel PC 2100 user's manual V1.11
Figure 84: Inserting the retaining clips
1 - 6 mm
Wall or
Figure 85: Fastening the retaining clips
Installation • Installation
165
Advertisement
Table of Contents
