Dodge ZB 2005 Service Manual page 151

5 - 26 BRAKES - BASE
PEDALS - ADJUSTABLE (Continued)
(4) Disconnect wiring connector at pedal motor
(Fig. 35).
Fig. 35 Pump Motor Wiring Connection
1 - MOTOR
2 - WIRING CONNECTOR
(5) Unclip and remove clutch push rod from clutch
pedal pin (Fig. 36).
Fig. 36 Clutch Push Rod To Pedal Connection
1 - PEDAL POSITION SENSOR WIRING CONNECTION
2 - CLUTCH PUSH ROD TO PEDAL CONNECTION
3 - CLUTCH MASTER CYLINDER
4 - PUSH PIN
(6) Disconnect brake booster input rod from brake
pedal as follows:
(a) Position a small screwdriver under center
tang on booster input rod retaining clip (Fig. 45)
(b) Lift center tang high enough to clear end of
pedal pin, then slide clip off pedal pin and discard.
Do not reuse clip.
(c) Slide booster input rod off brake pedal pin
(Fig. 37).
Fig. 37 Booster Input Rod Attachment To Pedal
1 - RETAINING CLIP
2 - BRAKE PEDAL PIN
3 - BOOSTER INPUT ROD
(7) Hold accelerator pedal up and remove cable
retainer and throttle cable from pedal (Fig. 38).
Fig. 38 Throttle Cable At Accelerator Pedal
(8) Remove nuts that mount accelerator pedal (Fig.
39).
ZB