Dodge ZB 2005 Service Manual page 10

ZB
MANUFACTURE PLATE
DESCRIPTION
The Manufacturer Plate (Fig. 2) is located in the
engine compartment on the passenger side rear cor-
ner of the hood. The plate contains five lines of infor-
mation:
1. Vehicle Identification Number (VIN)
2. Gross Vehicle Mass (GVM)
3. Gross Train Mass (GTM)
4. Gross Front Axle Rating (GFAR)
5. Gross Rear Axle Rating (GRAR)
METRIC SYSTEM
DESCRIPTION
The metric system is based on quantities of one,
ten, one hundred, one thousand and one million.
MULTIPLY
in-lbs x 0.11298
ft-lbs x 1.3558
Inches Hg x 3.377
(60° F)
psi x 6.895
Inches x 25.4
Feet x 0.3048
Yards x 0.9144
mph x 1.6093
Feet/Sec x 0.3048
mph x 0.4470
Kilometers/Hr. x 0.27778
(Km/h)
CONVERSION FORMULAS AND EQUIVALENT VALUES
BY TO GET
= Newton Meters
(N·m)
= Newton Meters
(N·m)
= Kilopascals (kPa)
= Kilopascals (kPa)
= Millimeters (mm)
= Meters (M)
= Meters
= Kilometers/Hr.
(Km/h)
= Meters/Sec (M/S)
= Meters/Sec (M/S)
= Meters/Sec (M/S)
Fig. 2 MANUFACTURER PLATE
The following chart will assist in converting metric
units to equivalent English and SAE units, or vise
versa.
MULTIPLY BY
N·m x 8.851
N·m x 0.7376
kPa x 0.2961
kPa x 0.145
mm x 0.03937
M x 3.281
M x 1.0936
Km/h x 0.6214
M/S x 3.281
M/S x 2.237
M/S x 3.600
INTRODUCTION 5
TO GET
= in-lbs
= ft-lbs
= Inches Hg
= psi
= Inches
= Feet
= Yards
= mph
= Feet/Sec
= mph
Kilometers/Hr. (Km/h)